Schluter DITRA HEAT E HK Floor Warming Cable - 240V

Schluter DITRA HEAT E HK Cable - 240v
Schluter DITRA HEAT E HK Floor Warming Cable - 240V
$166.92
  • Ships from Factory
    More than 5 Available In Store (More Info)
  • Free on orders over $99 in Continental US (More Info)
  • s_dhe_hk_240

  • Schluter

* Required Fields

Note: Most Schluter products are shipped factory direct, and are rarely back-ordered. Your order will ship in approximately 24 hours via UPS, and you may order more than the quantities it shows available. The quantities available reflect our in-store inventory.

The trademark of Schluter®-Systems is the exclusive property right of Schluter Systems L.P. and any commercial use is restricted except as permitted by law. Schluter.com

Product Description

Schluter DITRA-HEAT-E-HK Cables are twisted pair heating cables designed for integration with Schluter DITRA-HEAT uncoupling membrane in interior floor warming applications and feature:

  • Cables snap into the membrane; clips and fasteners are not required
  • No self-levelers required to encapsulate the cables; installation time significantly reduced
  • No return to thermostat required
  • Produces virtually zero electromagnetic fields
  • 120 V and 240 V options available in a variety of lengths

Important Ordering Information

  • Do not purchase a heating cable the same size as the area to be tiled; this will be too much heating cable!
  • Very important: Never CUT the heating cable. This would change the cable resistance and could lead to a fire.
  • Install the heating cable at a spacing of 3 studs (3-1/2" – 9 cm).
  • Minimum spacing from walls or fixtures (e.g., cabinets) is 3" (75 mm).
  • Minimum spacing from other heat sources (baseboard heaters, fireplaces, forced air heating ducts, etc.) is 8" (200 mm)
  • Minimum spacing from any plumbing drain is 6" (150 mm).
  • The heating cable section of the cable must be entirely installed under the floor covering. In order to prevent a fire hazard, do not install it anywhere else (e.g., in a wall).
  • Never install heating cable under vanities, bathtub platforms, kitchen cabinets and islands or any other fixtures. Excessive heat could build up in these confined spaces and may cause a fire.
  • It is helpful to plan the location of a buffer zone, as it is not possible to predict where the heating cable will end. The buffer zone is an area where heating is not essential, typically behind a toilet or adjacent to a door opening. This area allows for placement of excess heating cable.
  • Heating cable testing is required while the heating cable is on the spool and at two subsequent steps during installation to ensure cable quality and for warranty purposes. A megohmmeter is required for the insulation resistance testing of the heating cables.

 

Download Ditra Heat Installation Handbook
Download Ditra Heat Calculation sheet
Download Ditra Heat Data Sheet
Download Schluter Ditra Heat Brochure

Product Specifications

SKU: s_dhe_hk_240
Manufacturer: Schluter
Warranty: Limited 10 Year Warranty
Voltage: 240

Product Questions & Answers

+ Add Your Review

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Overall