The Weha Achilli AFR 300 C Wet Cutting Bridge Saw is designed for straight cutting, miter cutting, length cutting, and cross cutting stone slab and tile. The manual hand crank only takes about 10 turns to reach across the full 10' cutting length. X- axis movement down the bridge of the saw is powered by a manual crank. Y- axis blade height adjustment is powered by a hand crank directly on top of the motor and blade. This allows full control of blade height adjustment.
The AFR 300 C can cut up to 4" thick materials, has a 10", 12", or 14" blade capacity, and comes with two side extension tables that offer support for full slabs of stone. The side extension tables can be mounted on both sides of the saw.
Comes bascially fully assembled. After taking it out of the shipping crate, simply slide attach the legs, wire 220 single phase, mount the blade and side extension tables and start cutting. It is powered by a robust 3 HP (3400 rpm) motor that allows easy cutting of 2cm and 3cm stone without ever slowing down or over working the motor.
This Bridge Saw can also cut 45 degree bevel miter cuts. Simply loosen the hand knobs on each side of the bridge and manually tilt the entire bridge over to 45 degrees and tighten up the knobs. This feature allows very tight miter accuracy when cutting 45 degrees.
The cutting bed is made up of metal slats. This allows solid support of the cutting piece, allows the water to drain back down in the water tank, and allows easy access to the water tank if something falls in, or when the tank needs to be cleaned. The water tank on the AFR holds 64 gallons of water. By having an integrated water system, including a 1/2 HP water pump, built right into the AFR, it allows continuous and correct water flow back to the blade for water lubrication. Additionally this saves a lot of water by recycling the water. The AFR comes complete with a full 1 year manufacturers warranty.
- Manual bridge tilt from 90° to 45° to carry out bevel cutting.
- Manual adjustment of cutting depth.
- Fixed worktable with epoxy powder painted steel slats.
- Takes blades from 10"-14"
- Water tank with built-in recycling pump.
- Max Depth of Cut: 4"
- Length: 12'2"
- Width: 5'6"
- Height: 4'6"
- Weight: 719 lbs
Main motor (special voltage) Single-phase
- Power 2,2 kW (3HP)
- Voltage 230 V~
- Frequency 60 Hz
- Rotation speed 3400 RPM
Water recycling pump (standard) Single-phase
- Power 60 W (1/12HP)
- Voltage 230 V~
- Frequency 50 Hz
- Head 2,5 m (8,2 ft)
- Capacity 25 l/min. (6,6 gal/min.)
- Side extension table (2 pieces).
- Side stop (1 piece).
- Set of service tools.
|In the Box:||Weha Achilli AFR 300 C Bridge Saw Side extension table (2 pieces) Side stop (1 piece) Set of service tools|
|No Load Speed (rpm):||3400|
|Size (L x W x H):||12'2" x 5'6" x 4'6"|
|Max Depth of Cut (in):||4"|
|Wet or Dry:||Wet Only|
|Net Weight (lbs.):||719|