Ardex WA High Performance 100% Solids Epoxy Grout and Adhesive

Ardex WA Epoxy Grout is a 100% Solids, High-performance, solvent-free, two-component epoxy grout and adhesive.
As low as $85.00

Brand: Ardex

Availability: Sold in Store (More Info)

Shipping: Standard (More Info)

Only %1 left
SKU
AR WA 9

Ardex WA High-performance, 100% Solids Epoxy Grout and Adhesive is a solvent-free, two-component epoxy grout and adhesive.

Ardex WA Epoxy Grout Features:

  • Grout joints up to 1/2" (12 mm) wide
  • Use for setting all types of tile
  • Use where maximum chemical resistance and/or hygiene and cleanliness are required
  • Use for applications in food processing, industrial, institutional and commercial facilities
  • Ideal for swimming pools, hot tubs, and other wet areas, can be submerged after only 7 days
  • Very easy to clean with only water
  • Use for interior and exterior floors and walls
  • Waterproof and frost resistant
  • Solvent-free, low VOC’s
  • Coverage depends on tile size and grout joint size. See Ardex Grout Coverage Chart In Images

Download Product Overview
Download Technical Data
Download Safety Data Sheet (Resin)
Download Safety Data Sheet (Hardener)
Download Ardex Grout Color Brochure
Download Ardex Grout Color Specification

More Information
SKU AR WA 9
Weight (lbs.) 9.0
Non-Returnable No
Manufacturer Ardex
Write Your Own Review
You're reviewing: Ardex WA High Performance 100% Solids Epoxy Grout and Adhesive
Customer Questions
Do you have this product in slate grey. I know they make it, but didn’t see it n the color list.
Our apologies, we do not carry the Slate Grey.
How do you clean/remove the layer of epoxy on the tiles if the tiles get dirty before it dries?
If the epoxy grout is cured on the tiles you should try an epoxy grout haze remover like Miracle Sealants Epoxy Grout Film Remover. If the grout is just applied and has not cured, grouting sponge soaked in water should get any dirt and grout off the tiles. Please give us a call if you need further assistance. (800) 938-7925 and we can make recommendations for your situation.    
At what temperature can you install out doors.
This is from Ardex: At 70°F (21°C), the working time of ARDEX WA is approximately 1 hour, and the pot life is approximately 40 minutes. Jobsite conditions and temperature may affect working time and pot life. ARDEX WA is intended for installation at material and surface temperatures between 50° and 85°F (10° to 29°C). Do not install below 50°F (10°C) surface and air temperatures. For warm weather installation instructions, please contact the ARDEX Technical Service Department.  
Did you find what you were looking for?