DryTreat Stain-Proof Intensifia Colour Enhancing Sealer - Quart

Stain-Proof Intensifia Colour Enhancing Sealer – Richer Color Stronger Protection

The DryTreat Stain-Proof Intensifia Colour Enhancing Sealer is a breathable, semi surface / semi impregnating treatment, which enriches and enhances the natural color of porous surfaces as well as providing super oil and water repellency for superior stain protection. Treated indoor and outdoor surfaces are easier to clean and keep looking good for longer.

Color Enhancing Sealer is suitable for a wide variety of applications, including floors, walls, cladding, facades, countertops, patios, driveways, paths, garages, kitchens and entertaining areas.

Works on a wide variety of porous surfaces, including all types of natural stone, clay and terracotta tiles and pavers, brick, concrete, polished concrete, terrazzo, encaustic tile, terracotta and saltillo.

Suitable for indoor and outdoor applications and for residential and commercial buildings.

Key Features

• Deep colour enhancement
• Super oil and water repellency for superior stain protection. ISO 10545-14 Class 5 (best possible resistance to stains), greater than 98% reduction in 24-hour water up-take (Rilem method)
• Longer lasting, even outdoors under UV light
• Easy to apply. Additional coats can be applied at any time in the future to a cleaned surface
• Retains surface hardness and wet slip resistance of porous flooring materials
• Minimizes moss, mould and mildew growth, hides scratches, efflorescence and imperfections
• Breathable: water vapour permeates freely, avoiding moisture build-up inside the material

How To Use

1. Always test product on a small area first and allow a 24-hour cure time to check results.
2. Surface must be clean, dry and free of residues.
3. Generously apply Color Enhancing Sealer to a paint roller, clean brush or lamb’s wool applicator. Avoid contact with surrounding areas.
4. Allow for a minimum of 30 minutes for product to penetrate the surface then thoroughly remove any excess product residue with clean, dry, white cloths, towels or similar. This starts the chemical reaction and must be done. Do not allow excess to sit on surface between coats.
5. Leave the product to cure for at least 60 minutes, then repeat steps 3 and 4. Total application rate is approximately one quart per 20-250 sq. ft (2-25 sqm) depending on surface absorption. A third coat may be required for premium stain protection on very porous surfaces.
6. Avoid contact with moisture for a minimum of 8 hours after application. Full curing takes 4 weeks.
7. Use an organic solvent for e.g. methylated spirits to clean equipment.

Notes: Color Enhancing Sealer will not prevent etching from acidic liquids, or physical surface wear. The level of enhancement will vary dependent on the type of material being treated. It is advised to test on a sample piece before applying the product to your surface. Eventually, wear and tear and cleaning will affect the enhancement and sealing performance. Reapplication of the product will be needed. Once enhanced, the treated surface cannot be restored back to the original look.

Specification

• In Case of Fire: Use alcohol-resistant foam or normal protein foam for extinction.
• Packaging: 0.95L
• Coverage: 0.95 Litres Approx 15-25m².
• Storage: Store in a cool and well-ventilated place.

Downloads

Stain-Proof Intensifia Line Card
Stain-Proof Intensifia Application Rates
Stain-Proof Intensifia Overview
Stain-Proof Intensifia Technical Data Sheet
Stain-Proof Intensifia Safety Data Sheet
Stain-Proof Intensifia Product Uses And Porosity Chart